Technical Reference _________________________________________________________________
16 ________________________________________________________________ M211638EN-A
Get_Parameter_Info
The Get_Parameter_Info command (ID 83h) reads the properties of a
single parameter from the HMM105. The command is useful for adapting
to parameters that have been added in a new software version. If the
requested parameter ID is not valid, data type Unknown Parameter ID
is returned.
Table 22 Get_Parameter_Info Invoke Message
See section Checksum on page 9
Table 23 Get_Parameter_Info Response Message
See section Status Byte on page 9.
Parameter datatype. See Table 24
below.
Parameter length in bytes.
Parameter persistence. Describes if the
parameter value is volatile (lost at reset)
or non-volatile (survives reset). See
Parameter name. If the name is shorter
than 8 bytes, extra bytes are filled with
See section Checksum on page 9
Table 24 Parameter Data Types
Unsigned Integer (16–bit)
Table 25 Parameter Persistence
Commentaires sur ces manuels