Vaisala PTB330 Manuel d'utilisateur télécharger pdf (Page 62)

USER'S GUIDE____________________________________________________________________

60 __________________________________________________________________ M210855EN-D

Relay Settings

Relay Outputs

Figure 35 Relay Indicators on Display

The number refers to Figure 35 above:

1 = List enabled relays. Activation state is shown in black.

Disabled relays are not shown.

Use the display/keypad to

set the relay outputs:

1. Press any of the arrow buttons to open the MAIN MENU.

2. Select Interfaces and press the right arrow button to confirm

your selection.

3. Select Relay Outputs and press the right arrow button to

confirm your selection.

4. Select Relay 1/Relay 2 by pressing the right arrow button. Use

the up/down arrow buttons to select the quantity and press

SELECT to confirm your selection.

5. Select Quantity, press the CHANGE button. Select quantity by

using the up/down arrow buttons. Confirm your selection by

pressing the SELECT button.

6. Select Act. above/Act. below. Press the SET button. You may

be asked, whether you want to modify the value or remove the

setpoint. In this case, select MODIFY to adjust the value or

REMOVE to clear the setpoint. Adjust numeric values by

pressing the up/down/left/right arrow buttons. Confirm your

selection by pressing the OK key.

7. Select Hysteresis. Press the SET button and adjust the value.

Finally press the OK button.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 143 144

Pas de commentaire

Vaisala PTB330 Manuel d'utilisateur Page 62