Vaisala HUMICAP HMW90 SERIES Guide de l'utilisateur Page 23

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 72
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 22
Chapter 3 _______________________________________________________________ Installation
VAISALA _______________________________________________________________________ 21
Selecting Location
The conditions at the location should represent well the area of interest.
Do not install the transmitter on the ceiling. Avoid placing the transmitter
near heat and moisture sources, close to the discharge of the supply air
ducts, and in direct sunlight.
1111-070
Figure 8 Selecting Transmitter Location
Use the mounting holes to attach the mounting base securely. Use at least
two screws (not included, M3x6 recommended). Remember to leave
sufficient clearance below the transmitter to operate the slide. For
mounting dimensions, see section Dimensions in mm on page 69.
CAUTION
The arrow on the mounting base must point straight up after installation.
Proper orientation is important: air must flow through the vents on the
bottom and top.
Vue de la page 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 71 72

Commentaires sur ces manuels

Pas de commentaire