Vaisala WINDCAP WS425 Guide de l'utilisateur télécharger pdf (Page 31)

Chapter 3 _______________________________________________________________ Installation

VAISALA_______________________________________________________________________ 29

Connecting AC Power

1. Remove the protective cover plate over the AC power terminal

block.

2. Connect the AC power wires to the AC power terminal block as

shown in Figure 11 on page 30, starting with the green wire.

Double-check that each wire is connected as shown in Figure 11 on

page 30.

3. Restore the protective cover plate over the AC power terminal

block.

Connecting Sensor Interface Cable

1. Feed the sensor interface cable through the left hole at the bottom

of the power supply.

2. Use the conduit-nut to secure the conduit at the bottom wall of the

power supply box.

3. Connect the 12 ring lugs of the sensor interface cable to the 12-

position terminal block (see Figure 11 on page 30). Follow the

numbering scheme next to the terminal block and on the labels of

the individual wires.

CAUTION

Make sure you have correct mains voltage power supply

(WS425PowerUS or WS425PowerEU).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 90 91

Pas de commentaire

Vaisala WINDCAP WS425 Guide de l'utilisateur Page 31