User's Guide _______________________________________________________________________
44 ___________________________________________________________________ M211372EN-D
Output a Reading Once
Use the SEND command to output a single measurement message. The
output message is sent in the format that has been set using the FORM
command.
SEND [address]<cr>
Address of the transmitter, range 0 ... 255.
Specifying the address is only necessary if the target
transmitter is in POLL mode, and has not been accessed
with the OPEN command.
Example:
send
Tdf= 12.5 'C P= 0.991 bara T= 24.4 'C H2O= 15504 ppm
Tdfatm= 13.5 'C
Commentaires sur ces manuels