User's Guide _______________________________________________________________________
50 ___________________________________________________________________ M210865EN-F
Output a Reading Once
SEND [aa]<cr>
Transmitter address (0 ... 99). Must be specified if the
transmitter is in POLL mode, and a line has not been opened
using the OPEN command.
Example:
send
Tdf= -2.0 'C H2O= 5152 ppm
Troubleshooting and Maintenance Commands
Display the Currently Active Errors
Use the ERRS command to display the currently active transmitter error
codes. Possible errors and their causes are listed in Table 9 on page 61.
ERRS<cr>
Example:
errs
Voltage too low error
Commentaires sur ces manuels