Vaisala WMT700 Manuel d'utilisateur télécharger pdf (Page 35)

Chapter 4 _______________________________ Operating WMT700 in WS425 Analog Output Mode

VAISALA _______________________________________________________________________ 33

CHAPTER 4

OPERATING WMT700 IN WS425

ANALOG OUTPUT MODE

This chapter provides information on operating WMT700 in analog

output mode in a system configured for WS425.

NOTE

For general information on operating WMT700 with analog output, see

Vaisala WINDCAP

Ultrasonic Wind Sensor Series WMT700 User's

Guide.

Analog Output Settings

In analog output operation WMT700 takes measurements according to

the configured averaging time and synthesizes the analog outputs of wind

speed and wind direction with an update interval of 0.25 seconds. The

analog output signal type and range depend on the configured settings,

see Vaisala WINDCAP

Ultrasonic Wind Sensor Series WMT700 User's

Guide.

Normally analog output is enabled and the output settings are

preconfigured at the factory according to the customer order. You can

start using WMT700 directly after the installation with these settings.

However, you can change the analog output settings of WMT700 at any

time or disable the analog output functionality to save power over the

serial interface.

When operating WMT700 in a system configured for WS425, the analog

output settings must be configured according to Table 10 on page 34

using the S command. For more information on the S command, see S

Set Parameter in Vaisala WINDCAP

Ultrasonic Wind Sensor Series

WMT700 User's Guide.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 79 80

Pas de commentaire

Vaisala WMT700 Manuel d'utilisateur Page 35