Vaisala WMT700 Manuel d'utilisateur télécharger pdf (Page 44)

TECHNICAL REFERENCE___________________________________________________________

42 __________________________________________________________________ M211097EN-C

Getting Started

The communication profile and other settings have been configured at

the factory according to the customer specifications given when ordering

the product. You can start using WMT700 directly after the installation

with these settings.

In case you want to change the communication profile, you must also

check the other required parameters and change them if necessary. The

selected profile does not automatically change the settings. The

configurable parameters are listed separately for each profile in this

manual.

Operating WMT700 with Terminal Program

To operate WMT700 through a serial connection, the following

prerequisites are needed:

- PC with a serial port.

- Required cables for serial connection. For more information, see

section Before You Start on page 20.

- Any terminal program, such as Tera Term or Windows

HyperTerminal.

To switch on WMT700 in measurement mode using Windows

HyperTerminal:

1. Connect a cable between your terminal computer, power supply

and WMT700.

2. Open the Windows

HyperTerminal program.

3. Cancel the new connection.

4. From the File menu, click Properties.

5. Select the correct COM port and click Configure.

6. Set the communication parameters according to the configured port

settings of WMT700.

The default values for WMT700 are:

- Bits per second: 9600

- Data bits: 8

- Parity: None

- Stop bits: 1

- Flow control: None

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 79 80

Pas de commentaire

Vaisala WMT700 Manuel d'utilisateur Page 44