Vaisala WINDCAP WS425 Guide de l'utilisateur télécharger pdf (Page 110)

User's Guide ______________________________________________________________________

6. Set the communication parameters according to the

configured port settings of WMT700.

The default values for WMT700 are:

- Bits per second: 9600

- Data bits: 8

- Parity: None

- Stop bits: 1

- Flow control: None

7. Click Apply and OK.

8. On the Settings tab, click ASCII setup. Select ASCII

sending - Send line ends with line feed. Click OK and

close the New Connection Properties window.

9. On the View menu, click Font. In the Font list, select

Terminal.

10. From the Call menu, click Call. Enter a name and select an

icon for the connection. Click OK.

When a serial line cable is connected to the PC and the terminal

setup is correct, switch the sensor power supply on. The following

information is displayed to terminal screen:

WMT700 v<version number>

The sensor goes to measurement mode after four seconds and

it is ready to receive measurement mode commands.

At the end of each command, press ENTER to execute the

command. For a successful execution, the following combinations

of Carriage Return <CR> and Line Feed <LF> are accepted:

- <CR>

- <LF>

- <CR><LF>

Communication baud rate can be configured from 300 baud to

115200 baud. For available baud rates, see Appendix D,

Configuration Parameters, on page 205.

108 __________________________________________________________________ M211095EN-E

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 220 221

Pas de commentaire

Vaisala WINDCAP WS425 Guide de l'utilisateur Page 110