Vaisala WXT510 Manuel d'utilisateur télécharger pdf (Page 11)

Appendix A. Configuring the WXT510

Modifying the default configuration of the WXT510 requires the

purchase of a grey configuration cable; contact Campbell

Scientific for more information.

NOTE

1. Connect one end of the grey Configuration Cable to a COM port on the PC

and the other end of the cable to the “Service” connector on the WXT510.

2. Connect a 9 V battery to the Configuration Cable’s battery clip. The

female contact of the battery clip is (+).

3. On your PC, run Vaisala’s WXT Configuration Tool Software and go to

the Connection Setup Screen.

4. Enter the settings for each of the Connection Setup Screen’s parameters

(see Figure A-1). The default settings are:

• Connect using: enter the COM Port in which the Configuration

Cable is connected.

• Bits per second: 19200

• Parity: 8-N-1

5. Click on the OK button.

FIGURE A-1. Connection Setup Screen

A-1

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Vaisala WXT510 Manuel d'utilisateur Page 11