Vaisala HydroMet Guide de l'utilisateur télécharger pdf (Page 128)

User's Guide ______________________________________________________________________

126 __________________________________________________________________M210784EN-E

NOTE

When Value is expressed as N/A, it indicates that the calibration factor

has been altered but not saved, the sensor has not been measured or its

measurement channel has failed, or the sensor is disabled. Further

information about the possible reason can be obtained by comparing

the value in the Status column against the values listed in Table 30 on

page 127.

Table 29 Columns in the Sensor Calibration Tab

Column Description Input

Sensor The sensor name as

defined in the setup

n/a

Channel The measurement channel

of the sensor

n/a

ID The measurement identifier n/a

Status The sensor status n/a

Offset Offset for the sensors Overwrites the old offset value

with the new one.

Sensitivity The sensitivity value for the

radiation sensors (QMN10x

and QMS10x)

Overwrites the sensor

sensitivity value for the

radiation sensors.

Factor Measurement gain for the

sensors other than

radiation sensors

Overwrites the old gain value

with the new one.

Value The last measured sensor

reading shown in physical

units

Overwrites the sensor reading

with the entered value, that is,

changes the offset of the

measurement.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 159 160

Pas de commentaire

Vaisala HydroMet Guide de l'utilisateur Page 128