Vaisala HydroMet Guide de l'utilisateur télécharger pdf (Page 78)

User's Guide ______________________________________________________________________

76 ___________________________________________________________________M210784EN-E

Entering Values for Manual Sensors

Before you can manually enter data to the QML logger using the AWS

Client software, you must create and configure manual sensor(s) in

Lizard Setup Software. For instructions on creating a manual sensor,

see Chapter 3, Configuring Modules and Sensors, in Vaisala

HydroMet™ Data Collection Platform User’s Guide, Volume 3.

Viewing Manual Sensors in AWS Client

For each manual sensor included in your setup, you can view

information on the sensor’s status, the type of values for which the

sensor is used, and the range of valid values for the sensor. To view the

manual sensor information, proceed as follows:

1. On the Settings menu, select Manual Sensors. The list of

configured manual sensors is displayed.

2. Select the sensor on which you want to view information from the

list.

3. Select Edit. The information on the sensor is displayed as shown

in Figure 39 on page 77.

NOTE

New sensor calibration values are taken into use in the QML logger

after a reset with, for example, the Reset command. For further

information on resetting the QML logger, see section Resetting the

QML Logger on page 103.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 159 160

Pas de commentaire

Vaisala HydroMet Guide de l'utilisateur Page 78