Vaisala HUMICAP HMP46 Guide de l'utilisateur télécharger pdf (Page 26)

HMI41 AND PROBES

Operating Manual M210316EN-A

6.3 Setting the measurement duration

Turn the indicator on with the ON/OFF button, press immediately the button

HOLD and keep it pressed until the text REC AUTO appears on the display.

Press ENTER and a text similar to the following appears on the display:

bat

(previously set duration)

In this mode, you can set the time between the first and the last measurement

stored, e.g. 30 minutes or 3 days. When entering this mode, previously set

duration time appears on the display. If the previously set duration time is too

long for the current battery charge, the longest calculated duration time

possible appears instead. This is also indicated with the text 'MAX'. The

duration of the measurement can be set from 15 minutes to 7 days. The

batteries last for 7 days during data collecting provided that they are of the

same type as those delivered with the indicator.

Set the duration with buttons ▲ and ▼. The duration time can be selected in

steps according to the following:

• 15 min; 30 min

• 1 - 6 h: each pressing = 1 h

• 12 h

• 1 - 7 d: each pressing = 1 d

If the duration selected is too long for the current battery charge, the text 'BAT'

appears. Select a shorter duration time.

Press ENTER to set the measurement interval.

6.4 Setting the measurement interval

min

(previously set interval)

In this mode, you can set the time between two measurements stored, e.g. 5

minutes or 2 hours. When entering this mode, previously set interval appears

on the display. If the previously set measurement interval is too short for the

current memory capacity of the indicator, the shortest calculated measurement

interval appears instead. This is also indicated with the text 'MIN'.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 71 72

Pas de commentaire

Vaisala HUMICAP HMP46 Guide de l'utilisateur Page 26