Vaisala WINDCAP WS425 Guide de l'utilisateur télécharger pdf (Page 79)

Chapter 6 ____________________________________________________ Configuration commands

VAISALA _______________________________________________________________________ 77

NOTE

There is a 100-millisecond delay after which WMT700 takes the settings

into use. Do not send commands to WMT700 during this time.

BAUD x,y,z,w

where

x = Bit rate (300, 1200, 2400, 4800, 9600, 19200, 38400,

57600, or 115200)

y = Data bits (7 or 8)

z = Parity (n = none, e = even, o = odd)

w = Stop bits (1 or 2)

Example:

In this example the bit rate is set to 115200, data bits to 8, parity to none,

and stop bits to 1.

BAUD 115200,8,n,1

Display Port Settings

You can use the BAUD command to display the current serial port

settings.

BAUD

Wind Measurement Control Commands

MEAS — Single Wind Measurement

This command starts wind measurement based on the user-configurable

averaging time. WMT700 does not send the data message automatically.

Use the polling command to fetch measurement data in the required data

message format.

MEAS

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 135 136

Pas de commentaire

Vaisala WINDCAP WS425 Guide de l'utilisateur Page 79