Vaisala WINDCAP WS425 Guide de l'utilisateur télécharger pdf (Page 93)

Chapter 7 ________________________________________________________________ Operation

VAISALA _______________________________________________________________________ 91

CHAPTER 7

OPERATION

This chapter contains information on WMT700 operating commands,

protocols and data messages.

Getting Started

After WMT700 has been installed and configured, you can start

operating the wind sensor as follows:

- To receive wind measurement data through a serial connection as data

messages, use serial communication.

When using the WMT700 profile, see the operating instructions in this

section.

When using WS425 or SDI-12 profiles, see the operating instructions

in Upgrading from Vaisala WINDCAP

Ultrasonic Wind Sensor

WS425 to WMT700 Technical Reference.

- To receive wind measurement data as current, potentiometer, voltage,

or frequency output, use analog output.

For general information, see Analog Output on page 65.

For instructions on using WMT700 analog output in a system

configured for WS425, see Upgrading from Vaisala WINDCAP

Ultrasonic Wind Sensor WS425 to WMT700 Technical Reference.

NOTE

For a complete list of the serial commands available for the WMT700

series wind sensors, see Appendix A, Complete Command Set for

WMT700, on page 121.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 135 136

Pas de commentaire

Vaisala WINDCAP WS425 Guide de l'utilisateur Page 93