Vaisala HMP260 SERIES Manuel de service télécharger pdf (Page 22)

HMP260 SERIES

Operating Manual HMP260-U017en-1.5

16 1997-11-25

CH2 CURRENT OUTPUT

CH1 0 ... 1 VOLTAGE OUTPUT

CH1

CH2

CH1

X15

CURRENT OUTPUTS

0 ... 20 / 4 ... 20 mA

VOLTAGE OUTPUTS

0 ... 5 V / 0 ... 10 V

VOLTAGE OUTPUTS

0 ... 1 V

CH1

CH2

CH1

CH2

CH1

CH2

CH1

OPENED COVER OF THE HMP260

Fig. 4.2 Selecting the analogue outputs with jumpers

The software has to be informed which outputs are in use. This is done either

through the serial interface or the menus on local display when one is in use.

The serial command is AMODE and the display/keypad command "Mode

Analog outputs Mode" (see Chapter 5 Commands). If the outputs need to

be scaled, see serial command ASCL and the display command "Mode

Analog outputs Scale".

All the jumpers are used only with the 0...1 V outputs. When other outputs are

in use, the spare jumpers are kept in connector X55.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 117 118

Pas de commentaire

Vaisala HMP260 SERIES Manuel de service Page 22