Vaisala HMP260 SERIES Manuel de service télécharger pdf (Page 38)

HMP260 SERIES

Operating Manual HMP260-U017en-1.5

32 1997-11-25

5.4 Serial commands

More detailed descriptions of the serial commands can be found in Appendix

1. Here only the most commonly used command sequences are described. The

instructions on how to connect the HMP260 transmitters to serial bus are

given in Chapter 4.3.

Pressing ESC always interrupts any serial command being given. In the com-

mands <cr> stands for carriage return.

5.4.1 Analogue output commands

5.4.1.1 Setting the analogue outputs

Disconnect the security lock jumper!

AMODE a bb.bbb cc.ccc d ee.eee ff.fff <cr>

a = channel 1: U = voltage output

I = current output

bb.bbb = lower limit of channel 1

cc.ccc = upper limit of channel 1

d = channel 2: U = voltage output

I = current output

ee.eee = lower limit of channel 2

ff.fff = upper limit of channel 2

The bb.bbb, cc.ccc, ee.eee and ff.fff parameters are entered in volts or

milliamperes.

Example:

lower limit of channel 1 is 0 V and upper limit 1 V (U 0 1)

lower limit of channel 2 is 2 V and upper limit 10 V (U 2 10)

AMODE U 0 1 U 2 10 <cr>

Ch1 : 0.000 ... 1.000 V

Ch2 : 2.000 ... 10.000 V

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 117 118

Pas de commentaire

Vaisala HMP260 SERIES Manuel de service Page 38