Vaisala WXT520 Guide de l'utilisateur télécharger pdf (Page 42)

User’s Guide ______________________________________________________________________

40 __________________________________________________________________ M210906EN-C

0803-048

Figure 17 Grounding Jumper Location

To remove the jumper, you must open the transmitter. If you need to

access the screw terminals, you should remove the jumper at the same

time.

1. Loosen the three long screws at the bottom of WXT520.

2. Pull out the bottom part of the transmitter.

3. Remove the grounding jumper from the PCB.

4. Replace the bottom part and tighten the three screws. To make sure

that the radiation shield stays straight, do not tighten the screws all

the way in one go. Do not overtighten.

The following numbers refer to Figure 17 on page 40:

1 = Grounding jumper (remove for marine applications)

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 170 171

Pas de commentaire

Vaisala WXT520 Guide de l'utilisateur Page 42