Vaisala WXT520 Guide de l'utilisateur Page 115

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 171
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 114
Chapter 8 ____________________________________________ Sensor and Data Message Settings
VAISALA______________________________________________________________________ 113
Pressure, Temperature, and Humidity Sensors
Checking the Settings (aTU)
With this command you can check the current pressure, temperature and
humidity sensor settings.
Command format in ASCII and NMEA 0183: aTU<cr><lf>
Command format in SDI-12: aXTU!
The response in ASCII and NMEA 0183:
aTU,R=[R],I=[I],P=[P],H=[H]<cr><lf>
The response in SDI-12:
aXTU,R=[R],I=[I],P=[P],H=[H]<cr><lf>
where [R][I][P][H] are the setting fields, see the following section.
Example (ASCII and NMEA 0183, device address 0):
0TU<cr><lf>
0TU,R=11010000&11010000,I=60,P=H,T=C<cr><lf>
Example (SDI-12, device address 0):
0XTU!0XTU,R=11010000&11010000,I=60,P=H,T=C<cr><lf>
where
a = Device address
TU = Pressure, temperature and humidity sensor settings
command in ASCII and NMEA 0183
XTU = Pressure, temperature and humidity sensor settings
command in SDI-12
<cr><lf> = Command terminator in ASCII and NMEA 0183
! = Command terminator in SDI-12
Vue de la page 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 170 171

Commentaires sur ces manuels

Pas de commentaire