Vaisala DRYCAP DMT340 SERIES Guide de l'utilisateur télécharger pdf (Page 99)

Chapter 4 ________________________________________________________________ Operation

VAISALA _______________________________________________________________________ 99

5. Press EXIT to return to the basic display.

To select display units:.

1. Press any of the arrow buttons to open the MAIN MENU.

2. Press the ► arrow button to select Display.

3. Use the ▲▼arrow buttons to select Units. Confirm the selection

by pressing the right-hand arrow button.

4. Use the ▲▼ arrow buttons to select display units. Confirm the

selection by pressing CHANGE. The unit changes from metric to

non-metric or the other way round.

5. Press EXIT to return to the basic display.

NOTE

Changing the units by using the display/keypad has no effect on the

serial output units.

Using Serial Line

Use the serial line command FORM to change the format, and the

command UNIT to select metric or non-metric output units.

FORM

Use the serial line command FORM to change the format or select a

certain quantities for the output commands SEND and R.

FORM [x]

where

x = Formatter string

The formatter string consists of quantities and modifiers. If no formatter

string is entered, the command will display the currently active formatter

string. Note that the hash symbol "#" is shown as a backslash "\" when

viewing the current formatter string.

When entering the command, use the abbreviations of the quantities. For

more information on quantities, see Table 3 on page 19 and Table 4 on

page 20.

The modifiers are presented in Table 26 below.

Table 26 FORM Command Modifiers

Modifier Description

x.y Length modifier (number of digits and decimal places)

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 168 169

Pas de commentaire

Vaisala DRYCAP DMT340 SERIES Guide de l'utilisateur Page 99